SoCom .458 mags?

[Canthavenuthingood]

Need a SoCom .458 floor plate stamped .458 to build a magazine other than .223 or 5.56 for 10 round mag compliance.

Any idea where to get one?

Vick

[floogy]

Ebay? Or... Just get a set of steel stamps and hammer it into the floorplate. Harbor freight sells a set for $10-15 bucks. Use a pencil to mark straight lines, should take no more than a couple min per floorplate. 458 SOCOM. Done.

[MiriamCub]

Thanks TS, this one makes 6 M1as total now.

SA Socom
SA Bush
Polytech standard
3 SA NM loaded

I just picked up another 1K of 147 grain British milsurp from the 70s yesrterday as well. Dont know why I did that as Ive got more milsurp than Ill ever consume already, must be the OCD kicking in again.

I only shoot two of them. The Polytech standard  with irons is the range gun out to 400-500 along with one of the NM loaded with a Pride/Fowler 10x ranging scope seen here for precision work out to 800 yds though I only shoot to 600 yds with both presently. This scope is boring to use on known distances once dialed in at 100 yds.

I keep a 1000 yd rangfinder in the hard case with the scoped NM loaded and once the target is ranged, the scope makes you look good

[Ubermcoupe]

Need a SoCom .458 floor plate stamped .458 to build a magazine other than .223 or 5.56 for 10 round mag compliance.

Any idea where to get one?

Vick

Take an existing AR floorplate and mag body to a local engraver them have them labeled?